Coal pollution mitigation

Emissions controls at a coal fired power plant

Coal pollution mitigation, sometimes labeled as clean coal, is a series of systems and technologies that seek to mitigate health and environmental impact of burning coal for energy. Burning coal releases harmful substances that contribute to air pollution, acid rain, and greenhouse gas emissions. Mitigation includes precombustion approaches, such as cleaning coal, and post combustion approaches, include flue-gas desulfurization, selective catalytic reduction, electrostatic precipitators, and fly ash reduction. These measures aim to reduce coal's impact on human health and the environment.

The combustion of coal releases diverse chemicals into the air. The main products are water and carbon dioxide, just like the combustion of petroleum. Also released are sulfur dioxide and nitrogen oxides, as well as some mercury. The residue remaining after combustion, coal ash often contains arsenic, mercury, and lead. Finally, the burning of coal, especially anthracite, can release radioactive materials.

Mitigation technologies

Mitigation of coal-based pollution can be divided into several distinct approaches. Coal pollution mitigation seek to minimize negative impacts of coal combustion.

Precombustion

Prior to its combustion, coal can be cleaned by physical and by chemical means.

Physical cleaning of coal usually involves gravimetric processes, often in conjunction with froth flotation Such processes remove minerals and other noncombustible components of coal, exploiting their greater density vs that of coal. This technology is widely practiced.

Coal can also be cleaned in part by chemical treatments. The concept is to use chemicals to remove deleterious components of coal, leaving the combustible material behind. Typically, coal cleaning entails treatment of crushed coal with acids or bases. This technology is expensive and has rarely moved beyond the demonstration phase. During World War II, German industry removed ash from coal by treatments with hydrofluoric acid and related reagents.

Post-combustion

The wastes produced by the combustion of coal can be classified into three categories: gases, particulates, and solids (ash). The gaseous products can be filtered and scrubbed to miminize the release of SO_x, NO_x, mercury:

• SO₂ can be removed by flue-gas desulfurization
• NO₂ can be removed by selective catalytic reduction (SCR).
• Mercury emissions can be reduced by up to 95%.

Electrostatic precipitators remove particulates. Wet scrubbers can remove both gases and particulates.

Ash

The solid residue, coal ash, requires separate set of technologies but usually involves landfilling or some immobilization approaches. Reducing fly ash reduces emissions of radioactive materials.

Carbon capture

Main article: Carbon capture and storage

Several different technological methods are available for carbon capture:

• Pre-combustion capture – This involves the gasification of a feedstock (such as coal) to form synthesis gas, which may be shifted to produce an H₂ and CO₂-rich gas mixture, from which the CO₂ can be efficiently captured and separated, transported, and ultimately sequestered, This technology is usually associated with Integrated Gasification Combined Cycle process configurations.
• Post-combustion capture – This refers to capture of CO₂ from exhaust gases of combustion processes.
• Oxy-fuel combustion – Fossil fuels such as coal are burned in a mixture of recirculated flue gas and oxygen, rather than in air, which largely eliminates nitrogen from the flue gas enabling efficient, low-cost CO₂ capture.

Satellite monitoring

Satellite monitoring is now used to crosscheck national data, for example Sentinel-5 Precursor has shown that Chinese control of SO₂ has only been partially successful. It has also revealed that low use of technology such as SCR has resulted in high NO₂ emissions in South Africa and India.

Combined cycle power plants

A few Integrated gasification combined cycle (IGCC) coal-fired power plants have been built with coal gasification. Although they burn coal more efficiently and therefore emit less pollution, the technology has not generally proved economically viable for coal, except possibly in Japan although this is controversial.

Case studies

In conjunction with enhanced oil recovery and other applications, commercial-scale CCS is currently being tested in several countries.^{[by whom?]} Proposed CCS sites are subjected to extensive investigation and monitoring to avoid potential hazards, which could include leakage of sequestered CO2 to the atmosphere, induced geological instability, or contamination of water sources such as oceans and aquifers used for drinking water supplies. As of 2021, the only demonstrator for CCS on a coal plant that stores the gas underground is part of the Boundary Dam Power Station.

The Great Plains Synfuels plant supports the technical feasibility of carbon dioxide sequestration. Carbon dioxide from the coal gasification is shipped to Canada, where it is injected into the ground to aid in oil recovery. A drawback of the carbon sequestration process is that it is expensive compared to traditional processes.

The Kemper County IGCC Project, a proposed 582 MW coal gasification-based power plant, was expected to use pre-combustion capture of CO₂ to capture 65% of the CO₂ the plant produces, which would have been utilized and geologically sequestered in enhanced oil recovery operations. However, after many delays and a cost runup to $7.5 billion (triple the initial budget), the coal gasification project was abandoned and as of late 2017, Kemper is under construction as a cheaper natural gas power plant.

The Saskatchewan Government's Boundary Dam Integrated Carbon Capture and Sequestration Demonstration Project will use post-combustion, amine-based scrubber technology to capture 90% of the CO₂ emitted by Unit 3 of the power plant; this CO₂ will be pipelined to and utilized for enhanced oil recovery in the Weyburn oil fields.

An oxyfuel CCS power plant operation processes the exhaust gases so as to separate the CO₂ so that it may be stored or sequestered

An early example of a coal-based plant using (oxy-fuel) carbon-capture technology is Swedish company Vattenfall’s Schwarze Pumpe power station located in Spremberg, Germany, built by German firm Siemens, which went on-line in September 2008. The facility captures CO₂ and acid rain producing pollutants, separates them, and compresses the CO₂ into a liquid. Plans are to inject the CO₂ into depleted natural gas fields or other geological formations. Vattenfall opines that this technology is considered not to be a final solution for CO₂ reduction in the atmosphere, but provides an achievable solution in the near term while more desirable alternative solutions to power generation can be made economically practical.

Other examples of oxy-combustion carbon capture are in progress. Callide Power Station has retrofitted a 30-MWth existing PC-fired power plant to operate in oxy-fuel mode; in Ciuden, Spain, Endesa has a newly built 30-MWth oxy-fuel plant using circulating fluidized bed combustion (CFBC) technology. Babcock-ThermoEnergy's Zero Emission Boiler System (ZEBS) is oxy-combustion-based; this system features near 100% carbon-capture and according to company information virtually no air-emissions.

Other carbon capture and storage technologies include those that dewater low-rank coals. Low-rank coals often contain a higher level of moisture content which contains a lower energy content per tonne. This causes a reduced burning efficiency and an increased emissions output. Reduction of moisture from the coal prior to combustion can reduce emissions by up to 50 percent.

In the late 1980s and early 1990s, the U.S. Department of Energy (DOE) conducted projects called the Clean Coal Technology & Clean Coal Power Initiative (CCPI).

Financial impact

Whether carbon capture and storage technology is adopted worldwide will "...depend less on science than on economics. Cleaning coal is very expensive."

Cost of converting a single coal-fired power plant

Conversion of a conventional coal-fired power plant is done by injecting the CO₂ into ammonium carbonate after which it is then transported and deposited underground (preferably in soil beneath the sea). This injection process however is by far the most expensive. Besides the cost of the equipment and the ammonium carbonate, the coal-fired power plant also needs to use 30% of its generated heat to do the injection (parasitic load). A test-setup has been done in the American Electric Power Mountaineer coal-burning power plant.

One solution to reduce this thermal loss/parasitic load is to burn the pulverised load with pure oxygen instead of air.

Cost implications for new coal-fired power plants

Newly built coal-fired power plants can be made to immediately use gasification of the coal prior to combustion. This makes it much easier to separate off the CO₂ from the exhaust fumes, making the process cheaper. This gasification process is done in new coal-burning power plants such as the coal-burning power plant at Tianjin, called "GreenGen".

Country by country experiences

Local pollution standards include GB13223-2011 (China), India, the Industrial Emissions Directive (EU) and the Clean Air Act (United States).

China

Since 2006, China releases more CO₂ than any other country. Researchers in China are focusing on increasing efficiency of burning coal so they can get more power out of less coal. It is estimated that new high efficiency power plants could reduce CO₂ emission by 7% because they won't have to burn as much coal to get the same amount of power.

As of 2019 costs of retrofitting CCS are unclear and the economics depends partly on how the Chinese national carbon trading scheme progresses.

India

Pollution led to more than 2.3 million premature deaths in India in 2019, according to a new Lancet study. Nearly 1.6 million deaths were due to air pollution alone, and more than 500,000 were caused by water pollution. India has developed instruments and regulatory powers to mitigate pollution sources but there is no centralized system to drive pollution control efforts and achieve substantial improvements," the study said adding that in 93% of the country, the amount of pollution remains well above the World Health Organization (WHO) guidelines.

Canada

In 2014 SaskPower a provincial-owned electric utility finished renovations on Boundary Dam's boiler number 3 making it the world's first post-combustion carbon capture storage facility. The renovation project ended up costing a little over $1.2 billion and can scrub out CO₂ and toxins from up to 90 percent of the flue gas that it emits.

Japan

Following the catastrophic failure of the Fukushima I Nuclear Power Plant in Japan that resulted from the 2011 Tōhoku earthquake and tsunami, and the subsequent widespread public opposition against nuclear power, high energy, lower emission (HELE) coal power plants were increasingly favored by the Shinzō Abe-led government to recoup lost energy capacity from the partial shutdown of nuclear power plants in Japan and to replace aging coal and oil-fired power plants, while meeting 2030 emission targets of the Paris Agreement. 45 HELE power plants have been planned, purportedly to employ integrated gasification fuel cell cycle, a further development of integrated gasification combined cycle.

Japan had adopted prior pilot projects on IGCC coal power plants in the early-1990s and late-2000s.

U.S.

Main article: Fossil fuel regulations in the United States

In the United States, clean coal was mentioned by former President George W. Bush on several occasions, including his 2007 State of the Union Address. Bush's position was that carbon capture and storage technologies should be encouraged as one means to reduce the country's dependence on foreign oil.

During the US Presidential campaign for 2008, both candidates John McCain and Barack Obama expressed interest in the development of CCS technologies as part of an overall comprehensive energy plan. The development of pollution mitigation technologies could also create export business for the United States or any other country working on it.

The American Reinvestment and Recovery Act allocated $3.4 billion for advanced carbon capture and storage technologies, including demonstration projects.

Former Secretary of State Hillary Clinton has said that "we should strive to have new electricity generation come from other sources, such as clean coal and renewables", and former Energy Secretary Dr. Steven Chu has said that "It is absolutely worthwhile to invest in carbon capture and storage", noting that even if the U.S. and Europe turned their backs on coal, developing nations like India and China would likely not.

During the first 2012 United States presidential election debate, Mitt Romney expressed his support for clean coal, and claimed that current federal policies were hampering the coal industry.

During the Trump administration, an Office of Clean Coal and Carbon Management was set up within the United States Department of Energy, but was abolished in the Biden administration.

See also

Health and environmental impact of the coal industry

• Asia-Pacific Partnership on Clean Development and Climate – international non-treaty agreement among ASEAN countries launched on January 12, 2006Pages displaying wikidata descriptions as a fallback
• Biochar – Lightweight black residue, made of carbon and ashes, after pyrolysis of biomass
• Carbon capture and storage – Collecting carbon dioxide from industrial emissions
• Carbon sequestration – Storing carbon in a carbon pool (natural as well as enhanced or artificial processes)
• Carbon sink – Reservoir absorbing more carbon from, than emitting to, the air
• Climate change mitigation – Actions to reduce net greenhouse gas emissions to limit climate change
• Coal mining in the United States – Overview and history of coal production
• Coal phase out – Environmental policy intended to stop using coalPages displaying short descriptions of redirect targets
• Coal-water slurry fuel – Combustible mixture of coal particles in water
• Coke fuel – Coal product used in making steel
• Environmental impact of the coal industry
• Fluidized bed combustion – Technology used to burn solid fuels
• Kyoto Protocol – 1997 international treaty to reduce greenhouse gas emissions
• Refined coal – Product of the coal-upgrading technology that removes moisture and pollutants from lower-rank coals

Further reading

• Biello, David (January 2016). "The Carbon Capture Fallacy". Scientific American. 314 (1): 58–65. Bibcode:2015SciAm.314a..58B. doi:10.1038/scientificamerican0116-58. PMID 26887197.
• "Can the Earth be Coal-Friendly?". PBS Documentary (Wyoming). April 10, 2009.
• "Clean coal technology: How it works". BBC News. 2005-11-28. Retrieved 2010-01-02.
• Wald, Matthew L. (2008-08-27). "The Energy Challenge". The New York Times. Retrieved 2010-04-30.
• "In Clean Coal We Trust - or Do We?". ParisTech Review. October 15, 2013.
• "The Future of Coal An Interdisciplinary MIT Study". Massachusetts Institute of Technology. Retrieved 2009-03-29.

External links

• "International Energy Agency - Clean Coal Centre".
• "National Energy Technology Laboratory compendium homepage". Archived from the original on 2008-08-29.
• "Institute for Clean & Secure Energy". Archived from the original on 2009-03-02.
• "US federal Office of Clean Coal and Carbon Management".
• "Clean Coal Technology & The Clean Coal Power Initiative". US Department of Energy. Retrieved 2009-03-29.
• "Clean Coal Technology Compendium". National Energy Technology Laboratory. Archived from the original on 2008-08-29. Retrieved 2009-03-29.
• "Utah Clean Coal Program". University of Utah. Archived from the original on 2009-03-02. Retrieved 2009-03-29.
• "Institute for Clean & Secure Energy". University of Utah. Archived from the original on 2009-03-02. Retrieved 2009-03-29.